DRAWING TOOLS AND MATERIALS
VIEWS
- TECNO 12-18. Test on FRONT VIEWS.
- TECNO 12-18. Test on PLAN VIEWS.
- TECNO 12-18. Test on SIDE VIEWS.
- TECNO 12-18. Views 1.
- TECNO 12-18. Views 2.
- TECNO 12-18. Views 3.
- TECNO 12-18. Views 4.
- Educacionplastica.net. 10 3D models to get views. Basic and intermediate level.
Basic level |
Intermediate level |
ISOMETRIC PERSPECTIVE
- TECNO 12-18. Isometric perspective 1.
- TECNO 12-18. Isometric perspective 2.
- TECNO 12-18. Isometric perspective 3.
- Educacionplastica.net. 10 views to get 3D models. Level 0.
- Educacionplastica.net. 10 views to get 3D models. Level 1.
- Educacionplastica.net. 10 views to get 3D models. Level 2.
- Educacionplastica.net. Software to draw isometric perspectives.
- TECNO 12-18. Test on Reduction Scales. To perform the necessary calculations, it would be usuful if you have a calculator, paper, and pencil.
- TECNO 12-18. Test on Enlargment Scales. To perform the necessary calculations, it would be usuful if you have a calculator, paper, and pencil.
http://www.voki.com/pickup.php?scid=6958692&height=267&width=200
ReplyDeletehttp://www.voki.com/pickup.php?scid=6957720&height=267&width=200 this is my voki bilal 1ºC
ReplyDeletehttp://www.voki.com/pickup.php?scid=6942805&height=267&width=200
ReplyDeleterosa the sheet of paper was for mondey no¿?¿?¿?¿
ReplyDeleteYes, deadline is 10th December: http://tecnoinglish.blogspot.com.es/2012/11/basic-drawing-tools-and-materials.html
DeleteRosa I did the exercise of isometric views and the third one was too difficult I got nervous and give up... The other ones were easy and I did them right, I hope...
ReplyDeleteDon't worry, Andrea! I know it's MUCH more diffult to get the 3D model from the views than the views from the 3D model.
DeleteI think you need a piece of paper to do some different sketches. I need it as well!
Some views are tricky and they are not what you think they are. You have to look at projections with a very open mind. For example, a square in a plan view could be a square or... an inclined plane, a hole, an horizontal cilinder... When you find the solution, you know that it is correct because everything matches!
So... don't worry about that. I'm not going to give you a very difficult object in an exam. You will have more difficult models in Bachillerato, if you choose Technical Drawing. But you have to be trained, this is a question of practicing a lot.
Delete